Dedicated blades reduce the overall and sometimes critical “H” measurement and allow for some sizes a slightly bigger motor to be fitted than for the Club range, which improves performance.  The Thinline kits use the same shroud design as the Club range, whilst the High Profile Kits use the deeper section with the dedicated thicker core fan blades, which perform very well  in any size.    There are just a small number of sizes of High Profile Kits which are very popular and effective in tough conditions.

 Thinline Kits

*  Nominal blade size – see W, D, P*, H & S for overall dimensions
** Performance - At 0.15” ( 3.75mm) static pressure is the equivalent of a typical 1.5” (39mm) thick radiator.   Free air figures are always much greater and look more impressive but are not often relevant and therefore not shown here. Performance figures, intended as a guide, are shown for pulling mode, the most reliable.   Blowing performance is unreliable, as it has degrees of spill and wastage and is only used when space is tight.   ‘0’ Amp draw is taken at nominal 12V rating.   Normal test voltage is 13.5V, for 24V amp draw figure a typical reduction of 45% should be applied.

- add P for Pull or B for Blow to part number. e.g. TCF0911P
- add /24 to part number when ordering 24V.
- for Twin Kits add /TW to part number, e.g. TCF1111/TW

 High Profile

- add P for Pull or B for Blow to part number. e.g. HPC107P
- add /24 to part number when ordering 24V.
- for Twin Kits add /TW to part number, e.g. HPC107/TW

 Fan Motor Shrouds, as assembled for the Thinline range, and all the components are available separately.