Profan assemblies are designed to maximise the fan’s potential performance and are therefore fitted with the most powerful motor compatible with blade size and type.

The units are supplied with 90° mounts and threaded mounts. Profans are either dedicated Pullers or Blowers, all the other Pacet components , i.e. quickmounts, thermostats, brackets etc. are interchangeable. We recommend the use of Profans when large volumes of air need to be moved.

Profan Kits are a further development of the Thinline & High Profile range, where maximum performance is required and there is sufficient space for the bigger motor, with dedicated Pull or Blow blades. These kits have proved very popular particularly with competition customers or those requiring the very best performance. Either supplied as Fan/Motor/Shroud (FMS) assemblies or as complete kits.

The FMS assemblies are available for those who wish to make up their own assembly or replace the existing unit. Delete the prefix K from the part number when ordering the Profan FMS Assembly only.

Water resistant motors can be submerged for 3 to 4 hours are available on Profan models only - add /WR to part number when ordering. WR motors add 10mm to H measurement.

PROFAN KITS TECH SPEC

Part No	Blade Size*	View	W mm	D mm	P mm	Hmm	S mm	CFM**	m³/h**	Amps**
KPF0811	8"		214	241	238	89	35	566	960	4.5
KPF0911	9"		243	276	279	89	35	831	1408	5.6
KPF1011	10"		269	301	323	89	35	1049	1770	7.8
KPF1111	11"		294	324	324	89	35	1206	2044	9.5
KPF1211	12"		321	336	335	72	35	1519	2574	13.0
KPF1211/02	12"		321	336	335	90	35	1568	2656	15.4
KPF1311	13"		346	353	354	100	35	1763	2981	16.0
KPF1411	14"		367	373	374	100	35	1844	3126	17.8
KPF1510	15"		400	414	414	90	36	2060	3492	18.1
KPF1611	16"		406	418	418	100	35	2260	3830	20.2

* Nominal blade size – click on size to view technical diagram.
** Performance - At 0.15” ( 3.75mm) static pressure is the equivalent of a typical 1.5” (39mm) thick radiator.

Free air figures are always much greater and look more impressive but are not often relevant and therefore not shown here. Performance figures, intended as a guide, are shown for pulling mode, the most reliable. Blowing performance is unreliable, as it has degrees of spill and wastage and is only used when space is tight. ‘0’ Amp draw is taken at nominal 12V rating. Normal test voltage is 13.5V, for 24V amp draw figure a typical reduction of 45% should be applied.

If ordering please note:
- add P for Pull or B for Blow to part number. e.g. TCF0911P
- add /24 to part number when ordering 24V.
- for Twin Kits add /TW to part number, e.g. TCF1111/TW

FMS - Fan Motor Shrouds, as assembled for the Profan range, and all the components are available separately.