Easy to install complete fan kits for pulling as supplied, or blowing by turning blade over. Pullers are to be fitted on the engine side of the radiator whilst blowers fit in front. The Club range is most suitable for road cars and in some cases modest competition. For outright competition and difficult off-road conditions, see the Profan range. All Club Kits in both pulling or blowing mode have the vital finger guard as a standard safety feature.

PACET’s popular universal Club Kit range from 8" to 16" blade diameter.

Each kit consists of:

• a preassembled fan, motor and shroud unit with integral finger guard.
• adjustable capillary thermostat.
• wiring and quickmounts in fact all you need to make fitting quick and easy.
• The fan blade is supplied as a Puller but it can be quickly reversed into a Blower to fit in front of the radiator.

As an alternative to our Club Kit we can supply the fan - motor - shroud (FMS) preassembled unit with four 90 degree mounting lugs only. Accessories such as thermostats or quickmounts can be purchased separately as required

CLUB KITS TECH SPEC

Part No	Blade Size*	View	W mm	D mm	Hmm	S mm	CFM**	m³/h**	Amps**
CF22	8"		214	241	77	35	526	896	4.2
CF33	9"		243	276	77	35	800	1356	6.0
CF55	10"		269	301	77	35	1040	1762	7.2
CF44	11"		295	324	72	35	1180	2000	7.4
CF77	12"		321	333	62	35	1490	2525	7.2
CF80	13"		346	353	84	34	1613	2734	11.9
CF88	14"		367	373	87	35	1809	3066	12.6
CF99	16"		406	418	87	35	2054	3481	13.6

* Nominal blade size – click on size to view technical diagram.
** Performance - At 0.15” ( 3.75mm) static pressure is the equivalent of a typical 1.5” (39mm) thick radiator.

Free air figures are always much greater and look more impressive but are not often relevant and therefore not shown here. Performance figures, intended as a guide, are shown for pulling mode, the most reliable. Blowing performance is unreliable, as it has degrees of spill and wastage and is only used when space is tight. ‘0’ Amp draw is taken at nominal 12V rating. Normal test voltage is 13.5V, for 24V amp draw figure a typical reduction of 45% should be applied.

If ordering please note:
- add P for Pull or B for Blow to part number. e.g. TCF0911P
- add /24 to part number when ordering 24V.
- for Twin Kits an extra figure to denote the extra fan and components, e.g. CF77 becomes CF777. Twin kits include the same components as single kits, with one thermostat and one override switch.

FMS - Fan Motor Shrouds, as assembled for the Club range, and all the components are available separately.